VINTAGECHOP INSTAGRAM FEED

Sunday, 14 September 2014

Rigid panther rear sections

these are a direct bolt on. made here in house, all tig welded on a jig [thats built off a stock original rear end so all proportions are correct]. the axle plates are laser profiled to look like the original castings from 10 paces away [clearly they arent cast but have a vintage feel about them] also i have the dummy cast section on the bottom rail at the front.

they take the wheel and spacers from your swingarm bike, all you have to loose is the speedo drive.
if using stock swingarm wheel all you need to do for the brake anchor is a piece of square section drilled and tapped and attach it through the hole that i have already put in the left side in front of the axle

pricing is £300 plus postage. they are made to order so may take up to 2 weeks.

No comments:

Post a Comment

LinkWithin

Related Posts with Thumbnails